Embedded Files
The Adjust Text Positions function allows you to change the location of the stand Number, Name and Area on a stand which overrides the position set in Visual Settings.
The Adjust Text Positions function allows you to change the location of the stand Number, Name and Area on a stand which overrides the position set in Visual Settings.
Here is an example which shows the Numbers on the outside corners and the Areas in opposite corners on the adjusted block of stands:
Adjusting Text Positions
Adjusting Text Positions
1
1
Select the stands you would like to adjust the text positions for then click on the 'Adjust Text' button which is located on the Dynamic Ribbon.
TIP: You can also initiate this function by using the default Hot Key ' A '
NOTE: The Dynamic Ribbon will not appear if you have entities other than stands selected, to deselect the other entities and only select stands, press F3. Remember to press F3 again once finished so you can select other entities.
2
2
The following dialog box will now appear with the options to set the text positions:
Position Options:
Position Options:
Leave as is - This option leaves that particular piece of text in the same position
Centre - Position the text to the Centre
Top Left - Position the text Top Left
Top Right - Position the text Top Right
Bottom Left - Position the text Bottom Left
Bottom Right - Position the text Bottom Right
TIP: If you want to reset the text back to the default position set in Visual Settings, use the Reset Stand Text function.
Page updated
Report abuse